~8~
The cables that transmit the video signal are connected to the symmetrical connector of the camera. The
left 'H' terminal is a non-inverted signal in the phase. The right terminal is inverted in the phase by 180
degrees. The middle terminal is the signal ground of the video.
The camera should be connected to appropriate terminals in the CC-4000 control electronics (SLAVE or MASTER,
depending on the panel configuration)
7.
O
THER
Pressing the '#' key in the idle mode will refresh the settings and restart the LCD display. This can be helpful in
situations when the display will 'freeze' due to an electrical breakdown or incorrect operation.
Heating of the LCD display turns on when the temperature inside the panel housing drops below 5 degrees
Celsius. The heater has an additional protection against overheating the display. Heating power is about 3W.
The panel is equipped with a protection against reverse polarity, overvoltage, overcurrent.
A short circuit in any electric strike channel does not immobilize the system and should not damage any element.
After the short circuit, the panel is fully functional
Technical data of the device:
Supply voltage ............................................... 12-13.8V DC stabilized
Average current in PC-4000 ........................... about 70mA
LCD heater power consumption ..................... 250mA
Strikes max. power consump. ........................ 750mA
Camera power consump. ............................... about 100mA
IR illuminator power consump. ...................... 30mA
PC-4000 board max. current .......................... 1.2A
Dimensions .................................................... 270x100x33mm
Overcurrent protection ................................... 2.5A
Transmission speed RS-485 .......................... 3kbps
IR illuminator wavelength .............................. 850nm
RFID frequency ................................................ 125kHz
Max. speaker power....................................... 0.5W