
~7~
It is not possible to change the serial number with the programmer!
If you connect the programmer to the panel that is already part of the entry system installation, first connect the
programmer to the panel board, and then the programmer to the USB connector. Otherwise, the board or
programmer may be damaged due to possible overvoltages.
No power is required on the panel board to program or download settings from memory.
6.
C
AMERA MODULE
The camera consists of a 1/3 "colour CMOS sensor with a lens of an angle of view of 110 degrees and a video
signal balun and illuminator with infrared LEDs.
The angle of view of the camera can be adjusted within the 20 degree horizontal and 15 degrees vertical range.
Three nylon nuts are used for adjustment. During adjustment,
special care
should be taken so that the lens does
not rest on transparent polycarbonate. In addition, the nuts should not "go beyond" the threaded pins.