~4~
4.
C
ONNECTING
For correct operation the panel requires connection to CC-4000 control electronics. A detailed description can
be found in the manual for the CC-4000 board.
Connection of electro strike and output button on the figure below:
The main strike can be a jumper/strike/reversing strike with a maximum current consumption of up to 750mA.
After exceeding the maximum current, the panel will automatically disconnect this output.
The output button serves as an additional button that releases the main strike, it is a regular button.
'STRIKE2' is a current output without galvanic isolation, therefore it can control other devices only through an
additional relay. Its load capacity is 250mA.
It should be noted that
the housing of the panel is not a supply ground!
The panel can be powered from the CC-4000 electronics board or its own DC power supply (see the CC4000
system manual)
Below is the photo with the description of the connectors:
OUTPUT BUTTON
STRIKE2
MAIN
STRIKE