~3~
2.
G
ENERAL
The front panel is made of acid-proof weather-resistant metal sheet. The casing, however, is made of galvanized
steel.
Integrated energy-saving RFID UNIQUE 125kHz proximity card reader
Fully metal backlit keyboard
Large LCD alphanumeric display with backlight
Heated display
Light sensor
Backlight operation in day/night mode
Camera angle adjustment in the range of +/- 20 degrees
Control of two electric strikes independently
Possibility of settings change from the GC-2000 programmer
Installer LOGO
3.
I
NSTALLATION
If possible, the panel should be installed in places not exposed to weather conditions, such as rain or snow.
After forging the opening in the building wall or a fixed door leaf, the bottom of the intercom entry access panel
should be fixed with 4 screws with raw plugs by inserting them through the 4 holes in the bottom part of the entry
access panel. Dimensions of the bottom of the entry access panel - Height 255mm, Width 83mm, Depth 35mm.
Large openings are designed for routing cables connecting the entry system panel with the electronic module of the
control panel.
The front panel, after attaching the cover (visor) and sliding it into the bottom part of the system installed on the wall,
is screwed with two M4 TORX20 screws with a pin.
Avoiding external installation of the system by installing it inside the building (vestibule, windscreen) if possible.
Severely soiling the keypad (snow, mud) or wetting it may cause interference in its operation.
In the base of the flush-mounted box there is a M4 threaded pin to which a protective conductor
(ground) must be connected. If the panel is broken or non-grounded, a person may be
electrocuted by the call panel.