Cyclades AlterPath ACS, Справочник по командам

Страница: 55 / 420

AlterPath ACS Command Reference Guide
39
Device Access
Edit parameters according to the explanation provided in the following
table.
:
Parameter Description
Examples/ Valid
Values
conf.eth_ip Ethernet Interface IP address. 20.20.20.1
conf.eth_ip_alias Secondary IP address for the Ethernet
Interface (needed for clustering feature). 209.81.55.110
conf.eth_mask_alias Mask for secondary IP address above. 255.255.255.0
all.socket_port This value applies to both the local ports and
ports on Slave ACS. 7001+
all.protocol Depends on the application. socket_ssh,
socket_server, or
socket_server_ssh
all.authtype Depends on the application. Radius, local, none,
remote, TacacsPlus,
Ldap, kerberos,
local/Radius,
radius/local,
local/TacacsPlus,
TacacsPlus, local,
RadiusDownLocal,
LdapDownLocal,
NIS
s33.tty This parameter must be created in the Master
ACS file for every Slave port. Its format is:
IP_of_Slave:[slave_socket_port] for non-
Master ports. In this case, the
slave_socket_port value is not necessary
because s33.socket_port is automatically set
to 7033 by all.socket_port above. 20.20.20.2:7033
s33.alias An alias for this port. (This is an optional
parameter). server_on_slave1_
serial_s1
s33.ipno This parameter must be created in the Master
ACS file for every Slave port, unless
configured using all.ipno. 0.0.0.0
Table 2.2: Master configuration (where it differs from the CAS standard)