Testing the
Network
Connections
Before using the XP Administrator software, you must test the network connection
to every XPIA in the system. Follow the steps below:
1. Launch the XP Administrator program by double clicking on the XP4000
System Admin icon.
2. Click on the ‘Test’ icon to begin testing your connections.
3. The following menu will appear.
8
Enter the IP address of your XPIA module. Enter “admin” or “root” as the
username, and the password that you configured when you installed the card.
Note that the password is case sensitive.
4. Select ‘OK’. You will receive a message “Valid IP Address @ xxx.xxx.xxx.xxx”.
If you do not receive this message, contact your network administrator to verify
your IP address and/or network connection.
5. Repeat steps 3 and 4 for every XPIA in your system. It is recommended that you
have the same password for all XPIAs for easier system maintenance.
Your XP Administrator Utility is now properly configured for operation.
