CYBEX Eagle Row, Руководство владельца и по обслуживанию

Страница: 21 / 44

Cybex Eagle 11030 Row Owner’s Manual
Assembly
Page 4-5
7. Belt Routing.
Verify belt is routed through top of pulley bracket and A.
then route end of belt down to the top weight.
Carefully lift top weight and verify that the position of B.
the belt clamp (on the top weight) is aligned properly
with the top pulley bracket (on the machine). See
Figure 12.
Slide belt through slot in belt clamp. C.
Verify belt and insert are installed properly, as shown D.
in Figure 13A. NOTE: Do not install the insert
backwards as shown in Figure 13B.
Pull belt tight and secure belt to clamp with the two E.
set screws. NOTE: Torque set screws 300-350 in./lbs.
See Figure 14.
Place weight stack pin in each plate to verify proper F.
installation.
Without selecting any resistance, lift top weight up and G.
down (simulating normal operation).
Have an assistant verify that the belt is moving smoothly H.
and is routed straight from the top pulley bracket to the
to weight belt clamp.
Reinstall the six increment weights that were removed I.
in step 6B. See Figure 15.
Turn the Increment Weight Adjusting Knob to select all J.
15 lbs.
8. Install back shrouds.
Carefully place shroud back into position on the two A.
bottom screws. See Figure 16.
Figure 16
Screw
Figure 13A
Figure 13B
Stem
Belt
Insert
Stem
Belt
Insert
Figure 14
Belt clamp
Belt
Belt clamp
insert
Set screws
Figure 15
Grooves
Increment Weights
Correct belt routing Wrong belt routing
Top Pulley
Figure 12 (top view from pulley down to belt clamp)
Belt
Insert and Set Screws (not
shown) are on this side.
Increment
Weight
Adjusting
Knob