Quick reference guide
Find software, recommended accessories and tested games at
cybershoes.io/support
1
Turn on:
Press button on shoe
Turn off:
Press and hold button on shoe for
6
seconds (until red light is visible)
Shoes indicate charging state when on.
Shoes charge when off as well but do not indicate.
Change channel (multiplayer only):
1. SHOES: Press the button for power on
RECEIVER: connect with USB cable
2. wait for the 1 second LED light signal
3. wait until the 1 second LED signal goes off
4. then immediately press button and cycle through
the color-coded channels.
Google Youtube: „Cybershoes frequency“
Shoes and receiver must blink in the same color! If a shoe misses on receiver this shoe is set to the wrong channel.
Cyberchair
If not already removed: remove cap from gas lift.
Cable management with cable rectractor
In the Cybershoes package you find a cable retractor.
Attach it to a recommened tripod and with the
cable
tie
to the VR cable: see cybershoes.io/support
Headset to retractor: 90cm / 35“ (on cable)
Retractor to joint of tripod: 140cm / 55“ (on cable)
Height of retractor: 210cm / 82“ above ground
As an alternative you can mount the retractor to the
ceiling or to a suspended wire or wooden batten.
Recommendations for bar stool and cable management:
cybershoes.io/support > bar stools
&
cable management
Cable management with IKEA Regolit
Do not use the "last element" with the cable and lamp socket.
Cable management with AliExpress Ceiling suspension
Thrid party bar stool
Use gas lift that comes with cybershoes
cable tie
CHANGE CHANNEL BUTTON
CHANNEL INDICATOR LED
INPUT SPEED MULTIPLIER
ROLL
CHANNEL INDICATOR LED
CHANGE CHANNEL BUTTON
TO PC
