CyberOptics SE505, Руководство по оборудованию

Страница: 85 / 180

CyberOptics Corporation 75
Main Electrical Panel
Clean Inside of the Enclosure
➢
To clean inside of the enclosure
1. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 59.
2. Lift the system hood.
3. Make sure all motion has stopped.
4. Use a dry cloth to wipe debris off of the inside of the hood, conveyor rails, the gantry, etc.
Clean the Main Electrical Panel
➢
To clean the main electrical panel
1. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 59.
2. Open the hood on the SE505.
3. Make sure all motion has stopped.
4. Remove two screws that secure the lower front panel to the machine frame.
5. Using clean, dry, compressed air, remove the dust buildup from the main electronics panel.
Keep away from the system so the dust will not get into the electronics panel.
6. Replace the lower font panel.
7. Close the SE505 hood.
Warning:
Make sure the AC main circuit breaker is turned OFF and power is disconnected
from the mains before starting on any procedure.
i
Note: For residue such as solder paste, remove the substances from inside the system with clean,
dry cloth.