CyberOptics SE505, Руководство по оборудованию

Страница: 12 / 180

Chapter 1 : Safety
2 SE505 Hardware Manual
Safety Guidelines
The SE505 system is a measuring device intended for use in SMT production environment.
Use of this equipment in a manner not specified in the operating instructions may impair safe
operation which can cause serious injury.
General Guidelines
●
Read and follow instructions provided with all other manufacturer’s documentation.
●
Be alert and use common sense when operating any machinery.
●
Be sure that you understand the safety considerations and follow the regulations in your
manufacturing facility.
●
Do not place liquids or heavy objects on or in the SE505 unit.
●
Always wear a static control wristband to prevent damage due to static electricity. The SE505
has an electrostatic discharge plug on the front of the machine by the power buttons to plug
the wristband into.
●
Be sure the SE505 is properly grounded through the power connection. To avoid electric
shock, provide an earth ground connection.
●
Do not lean on the safety enclosure or the safety enclosure frame.
●
Do not remove the safety enclosure or disable the safety interlock mechanisms.
●
Do not run the system with panels removed.
●
Do not attempt to disassemble or repair any SE505 component without first contacting your
CyberOptics representative.
●
Use the SE505 system only indoors.
●
To avoid electrical shock, always turn off the power using the AC main circuit breaker before
servicing the unit.
●
Only personnel trained by a CyberOptics’ representative are recommended to operate the
SE505 because of the system’s moving parts.
●
Parts replacement and maintenance should be performed by trained maintenance personnel,
CyberOptics Representatives and CyberOptics Service and Support.
●
System operation should be performed by trained operators.
●
During maintenance or repair, all power sources to equipment or machinery shall be
removed and locked or tagged on the de-energized position.
●
Locks to assure against inadvertent energizing of the equipment or machinery.
Caution:
The system processor contains lithium batteries. There is danger of battery damage if
the battery is incorrectly replaced. Replace only with the same or equivalent type battery
recommended by the manufacturer (CR2032). Dispose of used batteries according to the
manufacturer’s instructions. Recommended that only CyberOptics’ personnels can perform the
replacement of lithium batteries.