Quick Reference
931826A
© 2021, CyberData Corporation, ALL RIGHTS RESERVED
© 2021, CyberData Corporation, ALL RIGHTS RESERVED
931826A
Quick Reference
Installation Method
The site where you install the switch may greatly affect its performance. When installing, please take the following into
consideration:
•
Test the PoE network drop before connecting the CyberData device.
•
Use caution when inserting or modifying connections and install the product in a clean, flat wall surface.
•
Ensure there are no temperature or humidity concerns in the intended environment. See the
Specs
tab at
https://www.cyberdata.net/products/011528
for the acceptable temperature and humidity operating ranges.
•
To prevent electrical issues, avoid installing in close contact with other electrical wires, next to in-wall insulation, or exposing
the circuit board upon completing the installation.
•
Never install components in wet locations or during lightning storms.
•
It is advised to consult a certified electrician for installation.
Typical Wall Installation
Parts
1
Plug in the network cable and angle in
2
Secure Unit with Faceplate Screws
3
Fold flagnuts down,
then insert into wall cutout and
tighten screws
(1) Low Voltage Bracket
(2) Faceplate Screws
(2) PCBA Mounting Screws
Accessory Kit
(1) PCBA
(1) Faceplate
Dimensions
Mount PCBA to Faceplate
Contacting CyberData
2.756 [70]
4.567 [116]
0.177 [4.5]
3.900 [99]
3.270 [83]
DIMENSIONS ARE IN INCHES [MILLIMETER]
Dimensions are in Inches [Millimeters]
2.250 [57.15]
3.875 [98.43]
Dimensions are in Inches [Millimeters]
Faceplate
PCBA
Mounting Screw
Sales: 831-373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website:
RMA Department: 831-373-2601 ext. 136
RMA Email: [email protected]
RMA Status:
Warranty Information:
http://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: 831-373-2601
Fax: 831-373-4193
The IP Endpoint Company
Installation Quick Reference
In-Wall 2-Port Gigabit PoE Switch
011528
Wall Cutout
