CyberData Corporation
3 Justin Court, Monterey, CA 93940
P 831.373.2601 | F 831.373.4193
CYBERDATA INFORMACAST ENABLED WIFI BUTTON SETUP GUIDE
Doc. 931822B Page 4
1.0 Preparing the Environment
The CyberData InformaCast Enabled WiFi Button is used to trigger a message through
InformaCast with a simple button press. The button does not register to InformaCast like a
typical InformaCast enabled device, but it does interact with the server.
To properly use the buttons CyberData recommends having already setup the InformaCast
Server, Speaker groups, and Service Location Protocol (SLP). The button uses SLP to discover
the server which allows for a faster deployment. If using SLP is not possible on the network, the
WiFi Button Utility allows the InformaCast Server to be set using the SNMP button.
The WiFi buttons will require the ability to contact the InformaCast server. This requires the
WiFi Access points the buttons connect to have the ability to communicate with the InformaCast
Server.
2.0 Installing the Tool
This section will walk through the setup of the CyberData Wifi Button Utility. This tool is
designed to setup and manage the buttons.
1.
Download and unzip the CyberData WiFi Button Utility.
2.
Double click on the wb_installer.exe file to start the installation.
3.
Once you have the Installer Setup Wizard window, press Next to begin.
Figure 2-1.
Installer Setup Welcome
