CXR FO SERIAL, Руководство пользователя

Страница: 18 / 22

Instruction manual FO SERIAL
Page 18
9. Troubleshooting
This chapter describes the operation phases of the FO and provides a diagnostic for most of the problems encountered during installation and
operation.
9.1. Power up
Trouble Check
Power-up
phases do not
progress

The mains power plug,

ON/OFF switch is on “ON” position

Power is applied to the chassis, electrical continuity on the fuse
receptacle

ON or flashing of the LED

on the front display
The FO does
not answer the
commands

LED

stays ON permanently. This LED flashes as soon as the
unit detects the terminal on the control port (DTR signal)

The CTRL plug at the terminal or PC used for the FO configuration.

The terminal parameters:19,200bps, 8 data bits, 1 stop bit, no parity

At power up and when a terminal is connected to the CTRL port
(signal DTR), the FO sends a welcome message
The Fibre
Optic Link
integrity is
down

Verify the crossing between the two fibres modem. Rx<->Tx

Clean the optic fibre and FO connector with a bomb of compressed
air to suppress any dust on the optic contact.

Any dust can degrade the transmission.

Use two FO modems of the same type with the correct fibre (multi-
mode or mono-mode)
If the trouble remains after the above verification, please contact your distributor or call CXR Hot Line
E-mail at: support@cxr.fr
Telephone: +33 (0) 237 628 804