P/N IM-C35KD Rev. C
2014 Commercial Wireless Systems International, LLC.
29
The Enter Old Password field will be highlighted and the blinking cursor will be under the first digit.
Enter the current password using the UP/DOWN and LEFT/RIGHT buttons. When the current
password is showing press the ENTER button and the Enter New Password field will now be
highlighted. Enter the new password and press the ENTER button to exit edit mode. Press the Cancel
soft key to abort the changes or the Save soft key to save the new password. You will be taken back
to the Initial Configuration Menu.
4.3.3 Base code Setup
The base code is the code that the enrolled devices use to know what CP-3500D they are reporting
to. When the CP-3500D is powered up it randomly chooses one of 252 random base codes to use. In
an installation where more than one CP-3500D is required, it is
mandatory
that the base codes be
different on each one so the devices will know which CP-3500D to report to. This is true where any
device, repeater or CP-3500D in one installation is in reception range of any device, repeater or CP-
3500D in the same or a different installation.
Warning: You must verify that each CP-3500D in
reception range of another has different base codes before enrolling any devices or repeaters.
If you change the base code after enrolling the devices then every enrolled device will have to
be deleted, have their base code cleared and then be enrolled again.
To look at the assigned base code and change it if necessary, highlight the Base code Setup menu
choice and press ENTER. The screen below will be shown.
To change the base code, press ENTER. The base code choices are 002 to 252. Base codes 000
and 001 are reserved for system use. Use the UP/DOWN buttons to choose the first digit in the code
then move the cursor to the second digit using the RIGHT button. Now enter the third digit the same
way. When the desired base code is displayed press the ENTER button to exit edit mode.
We
strongly recommend you do not change the base code unless absolutely necessary. Only
change it before enrolling any devices or repeaters. Changing it when devices, annunciators
and repeaters are enrolled will cause all enrolled devices, annunciators and repeaters to show
test failure.
When you are done making the desired changes press the Save soft key to save the
change and display the Initial Configuration Menu.
B a s e c o d e S e t u p
Ca n c e l
B a s e co d e : 0 2 7
Содержание CP-3500D
Страница 12: ...P N IM C35KD Rev C 2014 Commercial Wireless Systems International LLC 12 Figure 1...
Страница 21: ...P N IM C35KD Rev C 2014 Commercial Wireless Systems International LLC 21 Figure 2...
Страница 47: ...P N IM C35KD Rev C 2014 Commercial Wireless Systems International LLC 47 Figure 4...
