CWSI CP-3500D, Руководство по эксплуатации и установке

Страница: 10 / 79

P/N IM-C35KD Rev. C

2014 Commercial Wireless Systems International, LLC.
10
2.2 Compatibility
The following UL Listed RF devices are compatible with the CP-3500DControl Panel:
Commercial Wireless Systems International, LLC
A/C Repeater Model AR-5
– A/C powered repeater
WRA-3(R)(LG)
– Remote Annunciator
SR-5
– Wireless Relay receiver
Smoke Detector Model 300
– Photo Electric Smoke Detector with Integral Sounder
Smoke Detector Model 301
– Tandem Photo Electric Smoke Detector with Integral Sounder
Smoke Detector Model 302
– Photo Electric Smoke Detector without Sounder
Heat Detector Model 320
– 135° Heat Detector
Smoke Heat Detector Model 325
– Combination Smoke Heat Detector
Pull Station Model 310
– Manual Pull Station
Fire Transmitter Models 345(TS)
– N.O. EOL Supervised Transmitter
CO Detector Model 350
– Carbon Monoxide Detector with Integral Sounder
The following antennas are for use with the CP-3500D:
Commercial Wireless Systems International, LLC Models:
OM-1 Omni
– Isotropic gain 2.5 dBi, OM-2 Omni – Isotropic gain 1 dBi, OM-3 Omni – Isotropic gain 5
dBi, YA-1 Yagi
– Gain 15.2 dBi
The following UL Listed Digital communicators are compatible with the CP-3500D Control
Panel:
Silent Knight 5104B
Keltron SDACT, SDACT-2
Notification Appliances:
As listed in the Notification Appliance Compatibility section of this manual.
Manual Service
Mount the pull station on a UL listed non-metallic junction box. Use a separate UL listed non-metallic
junction box with minimum inside dime
nsions of (HxWxD) 5” x 3” x 2” to house the model 345(TS)
transmitter. The two junction boxes shall be closed nippled together using a non-metallic conduit
nipple. Wire the transmitter to the pull station N.O. contacts. Refer to the 345(TS) manuals for wiring
instructions.