Cutera Excel V, Руководство оператора

Страница: 19 / 102

13
EXCEL V OPERATOR MANUAL
D1025, REV H, 10/17
Disconnecting the System
1. Turn the keyswitch to the O (OFF) position.
2. Set the main circuit breaker to the OFF position.
3. Remove the power plug from the electrical outlet and wrap the power cable around the
cable wrap.
4. Place the footswitch on the footswitch storage mount on the rear of the laser console. Coil
the footswitch cable and store it inside the footswitch holder. Do not wrap the footswitch
cable around the power cable wrap.
Moving the System
1. Disconnect the system as described above.
2. Replace the vented filler cap with a sealed filler cap to prevent water from leaking.
3. Unlock the console wheels by disengaging the wheel locks.
4. Move the system console to the desired site. Position the console no less than 20
centimeters (8 inches) from walls, furniture or other equipment. Adequate space around
the system console ensures proper air circulation.
CAUTION
Always disconnect the system as described above when moving the
system any distance other than within one room. The handpiece(s)
may be dislodged from the holster(s) when the system is moved
over thresholds or uneven surfaces. Damage will occur to the
handpiece(s) if dropped.
WARNING
Water must be drained from the system if the system is stored in
temperatures below freezing. Freezing may result in damage to
critical or delicate components.
WARNING
Do not push the console over a threshold or other obstacle greater
than 10 mm in height. Doing so may cause the console to tilt,
resulting in user injury.
CAUTION
Never use the handpiece or umbilical cable to move the system.
Moving the system using the handpiece or umbilical may irreparably
damage the handpiece and/or the umbilical.