Custom Audio Electronics KPM202, Руководство пользователя, Страница: 96 / 116

11.1 Enable alignment
Device is provided with two sensors for alignment, placed as follows:
•
one mobile sensor on the lower lat
•
one mobile sensor on the upper lat.
To guarantee the alignment, it is necessary to correctly choose the sensor to use for the notch detection depending on the
type of notch and its location on the ticket.
To do this, you must enable the parameter “Notch/B.Mark Position” during the setup procedure (see chapter 6) and set the
correct value of this parameter as described in the following table.
SENSOR
USED
VALUE OF THE
“NOTCH/B.MARK POSITION”
PARAMETER
USING MODE
OF SENSORS
NOTCH TYPE
- Disabled - Alignment disabled
1 Bottom
Relection
Black mark printed on the non-thermal side of paper
2 Top
Relection
Black mark printed on the thermal side of paper
1 + 2 Transparent Transparence Hole between tickets or gap between labels
SENSOR 1
lower flat
SENSOR 2
upper flat
NOTE: For ease of understanding, the image shows the two lats represented in the same plane.
For ease of reference, for some models is represented only the internal printer group without the external plastic chassis.
96