Curtiss-Wright R-NET OMNI2, Техническое руководство, Страница: 29 / 164

Curtiss-Wright | PG Drives Technology
SK81935-01
R-net Omni2 Technical Manual | Chapter 2 – Operation | 29
CHAPTER 2 - OPERATION
1 GENERAL OPERATING PRINCIPLES
When the Omni2 is powered-up or awoken, then a screen such as below will appear. Power-Up can be via the On/Off button
on the Display Section or via a switch connected into the External On/Off Switch Jack; while Wake-Up can be via the User
Switch or a particular SID sequence if a User Switch is not fitted. See the Using the Omni2 without a User Switch section for
details of this sequence.
NOTE (OP, HP, IN)
This is a typical screen. Depending on SID type, programming or system configuration and status, there may be additional
icons. Refer to the LCD Screen Details section for further information.
The powerchair can now be driven with the SID. While driving, the speed of the powerchair will be indicated by the numeric
display and the graphical display.
WARNING (OP, HP, IN)
To prevent unintended operation, the control system must be switched off, whenever the occupant enters or exits the
powerchair. Curtiss-Wright accept no liability for losses of any kind arising from failure to comply with this condition.
2 USER MENU
If the Menu method of control is being used, then an operation of the User Switch will initiate the User Menu. The following
image shows a typical User Menu screen.