Curtiss-Wright R-NET OMNI2, Техническое руководство, Страница: 145 / 164

Curtiss-Wright | PG Drives Technology
R-net Omni2 Technical Manual | Chapter 9 – Specifications | 145
SK81935-01
2.2.6 COEXISTENCE ISSUES:
It is anticipated that the product will be used in the vicinity of other non-medical devices which share the 2.4GHz area of the
radio spectrum. The Bluetooth® protocol supports the Frequency Hopping Spread Spectrum (FHSS) technique, which will help
to mitigate co-existence issues due to interference. The Bluetooth® transmitter in this product is approved for conformance to
the Bluetooth® protocols by the Bluetooth® Special Interest Group (Bluetooth® SIG). For further information see
https://www.Bluetooth®.org/tpg/QLI_viewQDL.cfm?qid=30976.
Where the product is to be operated in the vicinity of medical devices which use a proprietary protocol in the 2.4GHz
spectrum, refer to the Bluetooth® Set-Up & Operations chapter for information about flight-safe mode operation.
2.2.7 EMC AND TELECOMMUNICATIONS STANDARDS:
Certifications for FCC, CE, Bluetooth® SIG.
2.2.8 WARNING REGARDING USE IN THE VICINITY OF RF SOURCES:
Not Applicable. The wireless functionality in this product is neither life-sustaining or life-supporting.
2.3 REGULATORY INFORMATION
2.3.1 USER ACCESS
NOTE (OP, HP, IN)
Regulatory information can be accessed within the Omni2 via the following sequence:

Enter the Settings Menu.

Select the Bluetooth® option.

Select the Regulatory option.
2.3.2 UNITED STATES
Contains transmitter module FCC ID: T9J-RN42
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.