Curtiss-Wright R-NET OMNI2, Техническое руководство, Страница: 140 / 164

Curtiss-Wright | PG Drives Technology
SK81935-01 140 | R-net Omni2 Technical Manual | Chapter 8 – Diagnostics
4 BASIC TESTS
After a repair has been completed, the following tests should be carried out. These are minimum recommendations;
depending on the nature of the original trip, then additional tests may be required.
WARNING (HP, IN)
These tests are a minimum recommendation only. It is the responsibility of the service person(s) to perform other tests
relevant to the original trip and powerchair type. Refer to the powerchair’s Technical Manual for exact information of other
tests. Curtiss-Wright accept no liability for losses of any kind arising from the carrying out of the described tests, or from
not carrying out additional relevant tests.
These tests should be conducted in an open space and a restraining device such as a seat belt should always be used.
Curtiss-Wright accept no liability for losses of any kind arising from failure to comply with this condition.
4.1 GENERAL INSPECTION
Make sure all connectors are securely mated.

Check the condition of all cables and connectors for damage.

Check the rubber gaiter or boot around the base of any joystick shaft for damage. Check visually only, do not handle
the gaiter.

Make sure that all components of the control system are securely mounted.

Do not overtighten any securing screws.
4.2 BRAKE TEST
These tests should be carried out on a level floor with at least one meter clear space around the powerchair.

Switch on the control system.

Check the screen remains on after initialization.

Operate the SID slowly forwards until you hear the parking brakes operate. The powerchair may start to move.

Immediately release the SID. You must be able to hear each parking brake operate within 2 seconds.

Repeat the test a further three times, operating the SID slowly backwards, left and right.
4.3 DRIVE TEST
With the maximum speed control in the minimum position, drive the powerchair in all directions, ensuring the drive is
comfortable and easy to control for the user.
Repeat the above but with the speed control set to maximum.