Curtis ALP3GT15A826 Скачать руководство пользователя страница 1

Страница: 1 / 10

Models Included:

• ALP3GT15A826

• ALP3GT32A826

• ALP3GT32A898

3. Connect the unit to electrical outlet with appropriate amperage rating (see serial tag on machine).

4. Once power has been supplied to the unit, flip the toggle switch to the ‘ON’ position (located on the rear of the unit), the water tank will

begin to fill. When the water level in the tank reaches the probe, the heating element(s) will turn on.

5. Water in the heating tank will require approximately a half hour before reaching operating temperature (factory setting of 202°F). When

the unit reaches operating temperature, it will display “READY TO BREW”.

BREWING INSTRUCTIONS

1. The brewer should be ON. Confirm this at the rear toggle switch, then press the ON/OFF button. Ready-to-Brew should be displayed.
2. Place an empty decanter on warmer plate.
3. Place a new paper filter into the brew cone.

6. Press the BREW button on the

control panel to start brewing.

5. Slide the filled brewcone into the

rails on the coffee brewer.

4. Pour the proper amount of ground

coffee into the brewcone.

ilbur

urtis

., i

Service Manual – Alpha McDonald’s Fresh-Trac

Important Safeguards/Conventions

This appliance is designed for commercial use. Any servicing other than cleaning and preventive maintenance should be performed by an

authorized Wilbur Curtis service technician.

• Do NOT immerse the unit in water or any other liquid

• To reduce the risk of fire or electric shock, do NOT open service panels. No user serviceable parts inside.

• Keep hands and other items away from hot surfaces of unit during operation.

• Never clean with scouring powders, bleach or harsh chemicals.

Symbols

WARNINGS – To help avoid personal injury

Important Notes/Cautions – from the factory

Sanitation Requirements

The Curtis Alpha G3 is Factory Pre-Set and Ready to Go… Right from the Box.

Following are the Factory Settings for the Alpha Fresh-Trac:

• Brew Temperature = 202°F

• Brew Volume = Set to vessel requirements (60 oz).

System Requirements:

• Water Source 20 – 90 PSI (minimum flow rate of 1 GPM)

• Electrical: See attached schematic for standard model or visit www.wilburcurtis.com for your model.

SETUP STEPS

1. The unit should be level (left to right - front to back), on a secure surface.
2. Connect the water line to the water inlet fitting on the rear of the unit. Water volume flow to the machine should be consistent. Use

tubing sized sufficiently to provide a minimum flow rate of 1 gallon per minute.

NOTE: A water filtration system must be used to help maintain trouble-free operation.

Air must be purged from the cartridge prior to

connection to equipment.

In areas with extremely hard water, we highly recommend the use of a Curtis approved water filter. For our

full line of filters, please log on to www.wilburcurtis.com.

NSF International requires the following water connection:

1. A quick disconnect or additional coiled tubing (at least 2x the depth of the unit) is required so that the unit can be moved

for cleaning.

2. This unit must be installed with adequate back flow protection to comply with applicable federal, state and local codes.

3. Water pipe connections and fixtures directly connected to a portable water supply shall be sized, installed and main

tained in accordance with federal, state, and local codes.