56446-INS-RA
•
06/15/2020
•
ECN7005
•
PAGE 1
Wiring Location Guide*
for SUVs and Vans (S)
S1
Behind driver side taillight housing
S2
Behind passenger side taillight housing
S3
Behind driver side rear access panel
S4
Behind passenger side rear access panel
S5
Behind driver side rear bumper
S6
Behind center of rear bumper
S7
Behind passenger side rear bumper
S8
Under rear floor panel
S9
Behind driver side rear access panel
S10 Behind passenger side rear access panel
S9
S10
S5
S6
S7
S1
S3
S8
S4
S2
* Representative vehicle shown
INSTALLATION MANUAL
Tools Required
Ratchet
Torx bit, T-20
Socket extension
Cutting tool
Fishwire
Wire crimper
Electrical Tape
Wire stripper
Flathead screwdriver --
Product Photo
Hardware Photo
Maintenance
Periodic inspection of all wires and connections should be performed
to ensure there is no visible damage or loose connections.
NOTICE
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
All steps must be followed to ensure the product will function properly. Once installed,
test for proper function by using a test light or connecting a properly wired trailer.
Level of Difficulty
Easy
Installation difficulty levels are based on time
and effort involved and may vary depending on
the installer level of expertise, condition of the
vehicle and proper tools and equipment.
Electrical Ratings
Signal circuits
6.0-amps per side
Tail / Running Circuits
3.0-amps total
Check vehicle owner's manual or contact
the vehicle manufacturer for more information.
WARNING
Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.
The battery connection must be fuse-protected, 10-amp max. Exceeding
the product rating can cause loss of warranty, overheating and potential fire.
Wiring Location(s)
S1 and S2
