Cupra BORN, Руководство пользователя

Страница: 207 / 343

Parking and manoeuvring
206
• The area for parking or manoeuvring should
be a flat surface.
• The vehicle should not be loaded very heav-
ily at the rear.
•
The driver must be used to the system.
• There should be no damage to the vehicle in
the camera area. If the position or installation
angle of the cameras have been changed, e.g.
after a rear-end collision, the system should be
checked by a specialised workshop.
Special characteristics
The images on the area view system cameras
are only two-dimensional. Due to a lack of spa-
tial depth, it is difficult or impossible to make
out on-screen any holes there may be on the
ground, objects jutting out from the ground or
parts protruding from other vehicles.
Situations in which the objects or other vehi-
cles appear to be further away or closer than
they really are:
• On moving from a horizontal plane to a
slope.
• On moving from a slope to a horizontal
plane.
•
If the vehicle is heavily loaded at the rear.
• If the vehicle approaches protruding objects.
These objects may be outside the cameras'
angle of visibility.
Note
To become familiar with the system and
its functions, CUPRA recommends that you
practice handling the Area View system in an
area where there is not too much traffic or in
a car park.
Connecting and disconnecting
Connect the reverse assist:
• Select reverse gear.
•
OR: in the infotainment system select >
Assistants > Parking assistant > Park assist .
Disconnect the reverse assist:
Drive forward at a speed of at least 15 km/h (9
mph).
Views of the peripheral vision sys-
tem (modes)
Depending on the equipment: con-
necting and disconnecting the ParkPi-
lot sound.
Exiting the Area View system screen:
Adjust the display: bright, contrast and
colour.
To select the camera you want to use, press the
thumbnail on the left side of the screen. Once
activated it will be highlighted in orange. You
can switch between views in the menu bar at
the bottom of the screen. The selected view
will be highlighted in orange.
The red lines are indicate a distance of approx.
40 cm away from the vehicle.
Aerial views (bird's eye view)
Main mode :
The vehicle and its immediate vicinity
seen from above are shown. Depend-
ing on the equipment, the ParkPilot's
path may also be displayed.
Front camera views (front view)
Cross traffic. This visualization helps to
monitor traffic to the left, front and
right of the vehicle and can be used,
for example, when exiting garages or nar-
row exits
Angle parking. The area in front of the
vehicle is shown. Orientation lines are
shown to give guidance.