Cupra BORN, Руководство пользователя

Страница: 160 / 343

Assistant systems Speed limiter
159
1
2
3
The limiter is reactivated automatically after re-
turning to less than the set speed.
Status display
When the speed limiter is switched on, the
instrument cluster display shows the saved
speed and the system status:
It lights up grey
The speed limiter is switched on but reg-
ulation is not active.
Lights up green
The speed limiter is switched on and ac-
tive.
WARNING
After use, always switch off the speed limiter
to prevent the speed being regulated against
your wishes.
•
The speed limiter does not relieve the
driver of their responsibility to drive at the
appropriate speed. Do not drive at high
speed if not necessary.
•
Using the speed limiter under adverse
weather conditions is dangerous and can
cause serious accidents, e.g. aquaplaning,
snow, ice, leaves, etc. Only use the speed
limiter when the status of the road and the
weather conditions allow it.
Operating the speed limiter
Fig. 127 On the multifunction steering
wheel: buttons to control the speed limiter.
Connecting
•
Press the button.
It does not take effect yet.
Start regulation
• While driving, press the button .
The current speed is saved as a limit speed.
Adjusting the speed
The programmed speed can be set:
+ 1 km/h (1 mph)
- 1 km/h (1 mph)
+ 10 km/h (5 mph)
- 10 km/h (5 mph)
Interrupting the adjustment
• Press the button.
The speed is stored.
Reinstating the cruise control
•
Press the button .
The limiter will re-activate as soon as the vehi-
cle is moving at a speed lower than the saved
one.
Switching off
•
Press and hold the button .
The speed limiter switches off and the speed is
deleted.
Switch to another driver assistance system
Depending on the equipment, you can switch
to the following driver assistance systems:
• Adaptive Cruise Control (ACC)
•
Speed limiter.
Press the button or slide your finger
over the button.
To select the desired system, swipe your
finger left or right.
Press the button
.
The speed limiter is switched off.