Cupra BORN, Руководство пользователя

Страница: 145 / 343

Driving
144
Disconnecting the drive system
Perform the following operations only in the
order indicated:
• Stop the vehicle.
• Park the vehicle
›››
page 188 .
•
Connect the electronic parking brake
›››
page 189 .
•
Please observe the indications on the Digital
Cockpit
›››
page 22 .
WARNING
When leaving the vehicle, always ensure that
the electronic parking brake is applied and
that all doors, windows, rear lid and front
bonnet are fully closed and locked.
Never leave the vehicle with the
drive system connected
If after stopping the vehicle you leave it with
the drive system switched on and a gear selec-
ted, the ignition and drive system switch off
automatically under certain conditions.
This protects the vehicle against unauthorised
use.
The electronic parking brake is applied auto-
matically
›››
page 189 .
If you then wish to continue driving, you have
to turn the ignition on again
›››
page 142 , e.g.
by depressing the brake pedal, along with the
drive system
›››
page 143 . If necessary, follow
the instructions in the Digital Cockpit.
Automatic operation of the side light
If the dipped beam is switched on when the ig-
nition switches off automatically, the side light
will turn on until the vehicle is locked, or for a
maximum of approx. 15 minutes.
WARNING
When leaving the vehicle, always ensure that
the electronic parking brake is applied and
that all doors, windows, rear lid and front
bonnet are fully closed and locked.
Electronic immobilizer
The electronic immobiliser helps to prevent
the drive system from being connected with
an unauthorised key and, consequently, the
vehicle being put in motion.
The vehicle key has an integrated chip which
automatically deactivates the electronic im-
mobiliser if there is a valid key in the vehicle
interior.
The electronic immobiliser is automatically ac-
tivated when there is no longer a valid key in-
side the vehicle.
For this reason, the vehicle's drive system can
only be connected with a correctly coded
Original CUPRA key. This type of key can be
purchased from a specialised CUPRA dealer or
any SEAT network dealer.
NOTICE
The correct operation of the vehicle is only
guaranteed with original CUPRA keys.
e-Sound
e-Sound is an electronically generated engine
sound to warn other road users of the pres-
ence of the electric vehicle.
e-Sound switches on when the drive system is
switched on.
As the speed increases, the e-Sound slowly
fades.
WARNING
e-Sound volume and audibility may be limi-
ted if there is snow or heavy soiling in the
front grille area. This can cause accidents.
• Before setting off, check that the front
grille area is not too dirty and clean it if nec-
essary.
•
The driver should always assume that other
road users have not heard the vehicle, even if
e-Sound is switched on.