Cupra BORN, Руководство пользователя

Страница: 135 / 343

Air conditioning
134
• Press the steering wheel heating function
button . The heating is switched on at its
maximum level.
• Press the function button repeatedly to set
the desired level.
• To switch off steering wheel heating, press
the function button several times until no LED
is on.
Cases where the steering wheel heating
switches on automatically
If you switch the drive system on again within
approx. 10 minutes, the steering wheel heat-
ing is automatically switched on at the last set
level.
Automatic disconnection
The steering wheel heating will be switched off
automatically when any of the following condi-
tions are met:
• Electrical energy consumption is too high.
•
The steering wheel heating system is faulty.
• If the ignition is switched off.
Troubleshooting
o The concentration of CO
2
in the
air of the vehicle’s interior is too high
The control lamp lights up red or yellow.
The following message may be displayed on
the instrument cluster screen:
Health risk!
High CO2 concentration. Open the
windows!
or Health hazard! CO2 very
high. Open all the windows now!.
•
Open all windows immediately.
• Have the system checked by a specialised
workshop.
The air conditioning does not work or
the CO
2
concentration cannot be measured
The control lamp switches on yellow.
The following message may be displayed on
the instrument cluster screen:
The air con-
ditioning is not working properly.
Go to the workshop.
• Have the system checked by a specialised
workshop.
The cooling system cannot be switched
on or its operation is limited
The cooling mode operates when the driv-
er's seat is occupied.
• Switch on the fan.
• Check the air conditioning’s fuse
›››
page 276 .
• Change the active combined filter
›››
page 308 .
•
If the fault continues, consult a specialised
workshop.
Change the temperature unit (Climatronic)
The temperature display can be changed from
Celsius to Fahrenheit on the Infotainment sys-
tem screen using the function button
> Set-
tings > Units .
Water or water vapour under the vehicle
If the humidity and temperature outside the
vehicle are high,
condensation can drip off
the evaporator in the cooling system and form
a pool underneath the vehicle. This is normal
and does not indicate a leak!
When the outside humidity is high and the am-
bient temperature is low, condensation water
may evaporate when the stationary air condi-
tioning is operating. In this case, steam may
be released from underneath the vehicle. This
does not mean that the vehicle has any dam-
age.
Stationary air condition-
ing
Introduction
With the stationary air conditioning you can
cool, ventilate and heat the passenger com-
partment while the vehicle is parked. In winter,
you can also demist the windscreen and leave
it free of ice and snow (if the layer is thin).