Parts and Materials Included:
1. Filter Head Assembly
2. Filter Cartridge
3. Faucet
4. 1/4" Union Adapter
5. 36" of 1/4" tubing
6
1/4" Feedwater Adapter
7. #2 Phillips Mounting Screws
Tools Required (not included):
• Drill (Cordless recommended)
• Adjustable wrench
• Phillips head screwdriver
• Razor knife or tube cutter
If a faucet hole needs to be drilled for faucet:
• Center punch
• File or grinding wheel
• 9/16" Drill bit (suitable for countertop
materials or cast iron/stainless steel sink)
1
2
4
6
5
3
1
2
4
5
3
6
• Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
before or after the system.
•
Installation must comply with state and local plumb-
ing codes.
•
Systems certified for cyst reduction may be used on
disinfected water that may contain filterable cysts.
EPA Establishment #070595-CT-001
•
System must be protected from freezing. Drain filter
when room temperature drops below 40°F (4.4°C).
•
Do not install on line pressure above 125 psi (862
kPa).
•
Do not install on hot water line. Maximum tempera-
ture allowed is 100°F (38°C).
•
The filter must be installed with the inlet and outlet
ports as labeled. Make sure not to reverse connec-
tions.
•
Do not use torch or other high temperature sources
near filter or plastic cartridges.
•
Do not install near electric wires or water pipes which
will be in the path of drill when selecting the position
to mount bracket.
•
Do not install in direct sunlight.
•
Allow a minimum of 2" (5 cm) clear space under filter
to facilitate cartridge change.
•
Mount filter in such a position as to prevent it from
being struck by other items.
GETTING STARTED
INSTALLATION PRECAUTIONS
We recommend that you change this filter every six months. However, local water conditions and actual volume of
water can affect filter life. Replace if a noticeable drop in pressure occurs at the faucet.
FILTER REPLACEMENT
