9
EXPERT WW rev.12
EXPERT WW
4. INSTALLATION SETUP
4.1. Setting the Time &
Date
1. Select:
Main menu
Time / Date
Wed May 12 200X
12 : 12 : 12 AM
2. Press the right-arrow key once. The current
month flashes on the display.
3. Use the adjustment buttons to adjust the
month.
4. Press the right-arrow key to step to the
next parameter.
5. Proceed in similar fashion to set the whole
time and date.
4.2. Password
The controller can use 3 password levels:
User 1 password [1-1-1-1]
This password provides access to temperature
set points, minimum ventilation settings and to
the animal count menu.
User 2 [2-2-2-2]
This password provides access to all menus
except for installation setup menus. This
password can be modified as explained
below.
Installer password [0-6-1-0]
This password provides access to all func-
tions of the controller. It can be modified as
explained below.
Choose an easy-to-remember password
and write it down in a safe place!
Using passwords is optional. Refer to the
Installation Setup section of this manual to
enable or disable passwords and to choose
the default password level (section 4.5). The
default user level is selected after 15 minutes
of inactivity.
4.2.1. Changing the Password
1. Select:
Main menu
Setup *
User
Password
* A password may be required to access this menu.
Password
Current mode
Installer
Change User
0 * * *
Change Password
* * * *
2. Use the adjustment buttons to set the first
number of the password then press the right-
arrow key. Proceed the same way to enter all
numbers of the password then press the right-
arrow key. The user is then identified.
3. If the installation password or user 2 pass-
word is posted, the prompt
“Change Password”
appears on screen. Use the adjustment buttons
to set the new password code.
4. Use the adjustment buttons to confirm
the new installer password then press the
right-arrow key to confirm the new password.
4.2.2. Retrieving a Lost Password
1. Select:
Main menu
Setup *
User
Password
User Password**
* If the controller prompts for a password, enter the
factory password (contact your dealer).
**This menu is accessible from the factory level only.
User Password
User 1:
1111
User 2:
2222
Installer:
0000
2. The password of all user levels are dis-
played on screen.
4.3. Controller Programs
Program definition:
Programs are an assembly of settings (tem-
perature settings, relay assignment, probe
assignment, etc.) that can be enabled at dif-
ferent moment of the breeding process. In all,
the controller can use 3 different programs.
Automatic program selection:
The controller can automatically switch the
program selection when the animals reach a
certain age and/or as a function of outside
temperature. Refer to the Installation Setup
section of this manual to enable or disable the
automatic program switch (see section 4.5).
Refer to the Installation Setup section of
this manual to set the number of pro-
grams in use and to enable or disable the
automatic program switch (section 4.5).
4.3.1. Program Selection & Settings
The controller can automatically switch the
program selection when the animals reach a
certain age and/or as a function of outside
temperature. If the automatic program switch
option is enabled in the Installation setup (sec.
4.5), you must indicate the moment at which
each program starts.
Make sure the right program is selected
before adjusting any parameter.
1. Select:
Main menu
Setup *
Program
* A password may be required to access this menu.
