Cumberland EDGE 890-00601, Инструкция по установке и эксплуатации

Страница: 63 / 258

Chapter 8: Equipment configuration
# of units — Enter the number of fans connected to the output selected. The CFM, minimum and
maximum amperages are modified automatically according to the number of units
Diameter — Enter the pit fan’s diameter. This field is populated automatically, and can’t be edited
when a brand and model was chosen from the drop down list
CFM — Enter the pit fan’s CFM. This field is populated automatically, and can’t be edited when a
brand and model was chosen from the drop down list
Min. Amp — Enter the minimum amperage if it differs from the proposed value
Max. Amp — Enter the maximum amperage if it differs from the proposed value
4. If desired, set the location of the pit fans by pressing on the localization button and roughly selecting
the location where the pit fans are located.
Once configuration is complete, the tile is green and displays the pit fan icon.
Configuring a sidewall fan
Information concerning many of the fans available on the market are programmed into EDGE. When you
select one of the brands and models that have been programmed, the known information is automatically
populated for you, making configuration as easy as possible. You can also enter custom sidewall fans
and enter the required settings manually.
1. Press on Sidewall Fans in the list of equipment on the left hand side of the screen and then press
on the icon.
2. Enter the name of your choice for the fan group, or leave the default name.
NOTE: If the name chosen is too long, it is truncated on the tile.
3. Set the following parameters:
Brand — Select a brand from the drop down list. Select Custom if the brand of your sidewall fan
isn’t programmed
Model — Select the model from the drop down list
Supply — Select the power supply
Enclosure — Select the enclosure where the sidewall fan is connected
Slot — Select the slot on which the fan group is connected from the drop down list
Output — Select the output on which the fan group is connected from the drop down list
Motor curve — This field is populated automatically, and can’t be edited when a brand and model
was chosen from the drop down list. You can edit this field when a custom fan is selected
# of units — Enter the number of fans connected to the output selected. The CFM, minimum and
maximum amperages are modified automatically according to the number of units. You can edit this
field when a custom fan is selected
Diameter — Enter the fan’s diameter. This field is populated automatically, and can’t be edited when
a brand and model was chosen from the drop down list
CFM — Enter the fan’s CFM. This field is populated automatically, and can’t be edited when a brand
and model was chosen from the drop down list
895-00693 EDGE 63