18
Error Code for Induction hob
Problem
Possible causes
What to do
E1
Signal lost (PCB failure) Please contact after sales service.
E2/E3
Abnormal high/Low in-
put voltage
Stop cooking and wait until input voltage back
to normal. If not please contact service center.
E4/E5/E6
Thermistor failure.
Please contact service center to repair.
E7
Abnormal high temper-
ature (dry burning)
Cut off power, wait for 30min and switch on. If
still not working, please contact service.
E8/E9
Failure of IGBT sensor
Please contact service center to repair.
E0
IGBT Overheat
Check if the fan is still working. If not please
contact service center to repair.
EE
Display PCB failaure.
Please contact service center.
The above are the judgment and inspection of common failures.
ATTENTION
!
To avoid danger, please do not disassemble the unit by your-
self!
Installation
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 50mm space shall be pre-
served around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-
resistant work surface material to avoid larger deformation caused by the heat
radiation from the hotplate. As shown below: