Cuisinart CTK17U, Руководство пользователя, Страница: 9 / 12

9
Instructions for Use
n
Before using for the first time we recommend operating the kettle 2
or 3 times. Fill to the MAX marked fill level, bring to the boil and when
boiling has finished and the kettle has switched off, discard the water
and rinse out the inside. This will remove any dust or residue remaining
from its manufacture.
n
Position the kettle on a flat sturdy surface with the spout facing away
from you. Gently lift off the lid, whilst holding the handle.
n
Fill the kettle with the required amount of cold water, the water gauge
is either side of the kettle and is marked with min and max, please take
care not to exceed the max mark as this may cause spitting from the
spout when boiling.
n
Position the kettle with the spout facing away from you. Replace lid on
kettle.
n
Align the kettle over the powerbase and gently lower it into position, it
will find its own way and sit firmly on the base.
n
Switch the kettle on by pressing down the power ‘On’ switch at the rear
of the kettle, you will hear a slight click and the switch will illuminate
with a blue LED.
n
The kettle will switch off automatically when it has completed the boil,
however, the kettle can be switched off at any time by simply lifting the
power ‘On’ switch in an upwardly direction, the LED will switch off and
the same click will be heard as switching on.
n
Pour water out slowly. Return kettle to base after pouring. If you wish to
re-boil the water, you must depress the power ‘On’ switch again.
N.B. A couple of water droplets or condensation may appear on the
powerbase, this is quite normal and not a leak.
N.B. Do not remove the lid of the kettle when pouring, escaping steam
may scald.
n
Once the kettle is re-located on the powerbase it can be switched on
again at any time, if the switch will not stay down it means the control
is still a little warm, this is normal and it will simply re-set itself in a few
seconds when cooled and will be ready to boil again.
n.B If the kettle is accidentally switched on without a sufficient water
level, a boil dry mechanism will automatically switch the kettle off.