CUBISCAN 150-T SETUP
QUICK REFERENCE GUIDE
UNPACKING
ADJUSTING PLATFORM HEIGHT
INSTALLING THE OVERHEAD ARM
This quick reference guide provides instructions for assembling and setting up the Cubiscan
150-T. For more detailed instructions on setting up the Cubiscan 150-T, see the
Cubiscan 150-T
Operations and Technical Manual.
1 Remove the Cubiscan 150-T, cables, calibration cube, and other tools and accessories
from the crate.
2 Remove any shipping material.
1 Using a forklift or pallet jack, lift the main assembly of the Cubiscan 150-T high
enough so that the retaining bolts can be removed.
2 Remove the retaining bolts with a 9/16” open end wrench.
3 Raise or lower the frame until the adjustment holes in the leg and frame are aligned
at the desired height.
1 Remove the retaining bolts from the mounting plates on the back of the base frame.
2 Lift the overhead arm into position and set the angled mounting plate on the
bottom of the arm assembly on the frame, aligning the holes.
3 Insert the retaining bolts through the mounting plate in the overhead arm assembly
and into the matching holes in the plate on the base frame and tighten them. Make
sure no cables are being pinched by the overhead arm.
4 Push the retaining bolts through the slotted holes in the frame and leg.
5 Thread the nuts on the bolts and tighten them.
6 Lower the frame back down.
801.451.7000
cubiscan.com
