CUBICON Style Plus-A15 Series
User Manual
Do not raise the temperature by more than 10% compared to the filament discharging
temperature which is a temperature during the normal use.
The clogging of the nozzle may get worse as the component of the filament gets changed.
If the filament doesn’t come out of the nozzle at all or it comes out very thin, do not
perform ‘
2. Cleaning the Inside of the nozzle using the Loading
’. It may cause a breakdown
as the filament gets cracked or it gets tangled in the Extruder.
3. Cleaning the Inside of the Nozzle Using the Nozzle Management Pin
If the printing quality doesn’t get enhanced only through the Loading or if the Loading can’t be executed, it
may be a case that the residues which can’t be removed only by the Loading still remain the inside of the
nozzle or a case that the clogging of the nozzle hole is severe. Clean the inside of the nozzle using the
nozzle management pin that has been supplied as an accessory by considering the below items.
①
Remove the filament inside the Extruder using the Unloading.
②
Heat up the Extruder by raising the temperature of the Extruder nozzle by at most 10% above
the discharging temperature of the filament that is expected to be remaining in the nozzle. It is to
sufficiently melt the filament that is remaining in the nozzle. If the Extruder nozzle is heated with
the temperature that is too high, the nozzle may get clogged as the filament that is remaining in
the nozzle gets carbonized, and therefore be cautious about the temperature.
③
While pressing down the filament push button (1), insert the nozzle management pin into the
nozzle (2), and clean the nozzle by pushing foreign substances in the nozzle down by moving it
54
