10
Please refer to the Network Management User
’s Manual for the detailed
management functions and required installation and operation procedures.
2. INSTALLATION
To properly install the Managed Switch, please follow the procedures listed
below. These procedures are described below in separate sections.
Installation Requirements
Unpacking the Managed Switch
Installing the Managed Switch
Power on the Managed Switch
Connecting the Managed Switch to the network
2.1 Requirement
Basic requirements for installation are as follows:
Environmental conditions
-
One power outlet
-
Proper ventilation
-
Proper isolation to electrical noise, radio, etc.
-
UTP cables should not run in the same duct with power and
phone line cables
Required SFP Transceiver or UTP cables
Rack mounting tools
2.2 Checking the Package Contents
Unpack the package carefully and check the package contents. The package
should contain the following items:
Standard
-
One Managed Switch
-
Mounting kit: 2 mounting brackets and screws (Fixed in the
Managed Switch when shipped)
-
Four rubber feet with adhesive backing
-
Console RS-232 cable with RJ-45 connector
