Trademarks
CTS is a registered trademark of Connection Technology
Systems Inc. Contents subject to revision without prior notice.
All other trademarks remain the property of their owners.
Copyright Statement
Copyright
Connection Technology Systems Inc.
This publication may not be reproduced as a whole or in part, in
any way whatsoever unless prior consent has been obtained
from Connection Technology Systems Inc.
FCC Warning
The CVT-3002-PLUS Series converters have been tested and
found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These standards are
designed to provide reasonable protection against harmful
interference when these devices are operated in a commercial
environment. These devices generate, use, and can radiate
radio frequency energy and may cause harmful interference to
radio communications unless installed in accordance with this
User’s Guide. Operation of these devices in a residential area
is likely to cause harmful interference which will make the user
responsible for the appropriate remedial action at his / her own
expense.
CE Mark Warning
These are Class A products. In a domestic environment these
products may cause radio interference in which case the user
will need to consider adequate preventative methods.
1. Checklist
The package should contain the following items:
- CVT-3002-PLUS Converter
- AC-DC Power Adapter
- User’s Guide
Please notify your sales representative immediately if any items
are missing or damaged.
2. Overview
CVT-3002-PLUS is designed to meet the massive needs for
Gigabit network deployment and able to extend a copper based
Gigabit network via fiber cable to a maximum distance up to
80KM.
CVT-3002-PLUS is fully compliant with IEEE802.3, 802.3u,
802.3ab & 802.3z standards. It can be installed into a CVT
Converter RACK. The installation & operation procedures are
simple & straightforward. Operation status can be locally
monitored through a set of Diagnostic LED located in the front
panel.
Major Features:
- Auto-Negotiation in TX port
- MDI/MDIX Auto-Crossover supported
- Support Flow Control
- Support Link Alarm
- Support Jumbo Frame 9K bytes (under 10,100,1000Mbps)
- Store and Forward Switching Mechanism
- Support Auto & Force mode configuration
3. Installation
- Attach fiber cable from the CVT-3002-PLUS to the fiber
network. The fiber connections must be matched – transmit
socket to receive socket.
- Attach a UTP cable from the 10/100/1000BASE-T network
to the RJ-45 port on the CVT-3002-PLUS.
- Connect the power adapter to the CVT-3002-PLUS and
check that the Power LED lights up. The TX Link/Act and
F/O Link/Act LEDs will light up when all the cable
connections are satisfactory.
4. DIP SWITCH Setting
The default setting for PIN 1 and 6 is ON. The rest of Pins are
OFF.
Pin NO.
Function
OFF
ON
1
TP Auto-Negotiation
Disable
Enable
2
Manual TP speed
10M
100M
3
Manual TP speed
N/A
1000M
4
Duplex mode
Half
Full
5
Flow Control
Disable
Enable
6
F/O mode
Force
Auto
7
Link Alarm
Disable
Enable
8
Transmission
mode
Store and
forward
Pass-through
NOTE:
1. Before changing TP speed, duplex mode and flow
control setting, please make sure PIN 1 is set to OFF.
2. When TP speed is set to 10M or 100M manually, PIN 3
needs to be turned OFF.
3. Under 1000Mbps, it supports full-duplex mode only.
4. When Pin 8 is set to ON and the TP speed to 1000M,
full-duplex mode and flow control are disabled.
Figure 3. CVT-3002-PLUS Converter Rear Panel
Figure 1. CVT-3002-PLUS dual fiber Front Panel
Figure 2. CVT-3002-PLUS WDM & SFP Front Panel
