Z45X SERIES INDUSTRIAL CONTROLLERS - DECEMBER 23, 2020
6
Getting Started
Default Factory Settings
Factory default settings are defined in the table below. Factory settings can be restored
any time by pressing and holding the default switch for 5 seconds and releasing it when
the service and link LEDs begin a repetitive (red/orange) flashing routine. At that point
the device will reboot (power-cycle) and will return to service with the factory defaults
in place.
Setting or Parameter
Factory Default
Administrative User ID
ctek *** Change after first login ***
Administrative password
ctek *** Change after first login ***
Administrative IP address
192.168.1.10
Network Configuration
Gateway
DHCP Server
Enabled
Administrative LAN and WAN port
Port 80 – See security section below
Firewall Status
Enabled – See security section below
WAN Ping Response
Disabled – See security section below
NAT Traffic to WAN
Enabled – See security section below
XML Interface
Disabled – See security section below
IP White List
Disabled – See security section below
SMS Management
Disabled – See security section below
SMS White List
Disabled – See security section below
SSH (Secure Shell) Access
Disabled – See security section below
SSH User ID
root – See security section below
SSH Password
pass – See security section below
Enable HTTPS
Disabled – See security section below
Connection State (WAN)
Enabled
Time Source
Cellular Network
Location Source
GPS (Internal)
DNS Address Source
Acquire from Wireless Network
Radio module firmware
Verizon - SWI9X15C_05.05.63.01 or newer
