CTE B-LIFT PRO Series, Инструкция по эксплуатации и техническому обслуживанию, Страница: 94 / 148

I n s t r u c t i o n s f o r U s e
a n d M a i n t e n a n c e
Section F
22
Stabilisation retraction
L2 L1 L4 L3
SA2
HN6
HN5
P
H3
From the frame station, move the selector SA2
In this phase, the lights HN5 and HN6 in the "outrigger
controls" left position of the basket will be on.
Having positioned the aerial part of the lifting platform
at rest, all of the outriggers can be retracted by
means of the four levers
L1, L2, L3, L4 .
If nothing moves, it means that the booms of the
platform are not in the correct position.
ATTENTION
Check the complete retraction of
the outrigger feet placed on the
opposite side of the controls.
When the outriggers have retracted completely, the
light
HN5 will turn off.
At this point, the beams can be retracted manually.
Disconnect any outside auxiliary networks which the
platform may be connected to (electrical, water,
pneumatic systems, etc.).
ATTENTION
Make sure that when the outriggers and beams are completely retracted, the light H3
in the cabin is off.