CTE B-LIFT PRO Series, Инструкция по эксплуатации и техническому обслуживанию, Страница: 77 / 148

I n s t r u c t i o n s f o r U s e
a n d M a i n t e n a n c e
Section F
5
Vehicle engine - power take-off
If possible, position the vehicle next to the work point
to be reached and prepare the lifting platform:
- Leave the engine of the vehicle running.
- Pull the park brake.
- Position the gear in neutral.
- Press the clutch pedal to facilitate coupling of the
hydraulic pump.
- Insert the PTO by means of the coupling lever
PTO .
- Release the clutch pedal.
- The light H1 on the cabin control panel will be on.
- Position the magnetic spotlight HR1 on the truck
roof and activate it inserting the connector in the
lighter plug.
- Adjust engine revs by means of the vehicle's manual
regulator at a speed of about
900/ 1000 rpm . Some
vehicles have automatic adjustment and therefore it
is not needed.
The engine start and stop control is also located in
the basket (s
elector SC8 ).
ATTENTION
Before starting any manoeuvre
(in cold weather), it is advisable
to idle the oleodynamic plant
pump for a few minutes, so that
the oil reaches the minimum
operating temperature (about 40°)
to allow it to flow correctly.
Operation
P
UM0937
UM0936
H1
PTO
PTO
HR1
ON
OFF
ON
OFF
M
OFF
ON
M
SC8