10
Aerial work platform
B-LIFT 18 HV
COD. UM0287_GB | REV. 0.0 | ED: 09/18
GB
Chapter 6
PROCEDURES FOR USE
6.5
The S3 system control panel (Smart Stability System)
1
4
3
2
5
Fig.
6.7
The control panel makes it possible to diagnose and calibrate the components in the
S3 system
(
Smart Stability System).
To use the panel, the system needs to be powered on (control panel on and PTO inserted).
CAUTION
The system's components can be calibrated only by staff authorised by the
manufacturer. For this reason, access to the related menu is password protected.
To access the diagnostics menu:
•
press the MENU button (Fig. 6.7 - 4) for about 3 seconds;
•
use the UP (Fig. 6.7 - 2) and DOWN (Fig. 6.7 -3) buttons to scroll through the pages of the menu:
-
BOOM ANGLE DIAGNOSTICS
-
SW RELEASE DIAGNOSTICS
-
CHASSIS LEVELLING
-
DIAGNOSTIC INPUTS
-
STABILIZER/OUTRIGGER DIAGNOSTICS
-
CHASSIS CTRL UNIT DIAGNOSTICS
-
PLATFORM CTRL UNIT DIAGNOSTICS
-
TIPPING PARAMETERS DIAGNOSTICS
-
PLATFORM WEIGHT DIAGNOSTICS
-
BOOM LENGTH DIAGNOSTICS
-
TURRET ANGLE DIAGNOSTICS
•
press the ENTER button (Fig. 6.7 - 5) on the required page to access the corresponding sub-
pages;
•
use the UP buttons (Fig. 6.7 - 2) and DOWN (Fig. 6.7 - 3) to browse the sub-pages;
