2
Aerial work platform
B-LIFT 18 HV
COD. UM0287_GB | REV. 00 | ED: 09/18
GB
Chapter 3
DESCRIPTION AND TECHNICAL DATA
3.1.1
Classiication
This machine has been designed to lift and move people and equipment within the platform’s (
AWP
)
maximum permissible load to positions located within the working envelope.
The platform should only be accessed on the ground via the gate.
The limitations on use are described in this manual. Any mode or condition of use that does not fall
within the limitations of use described in this manual and not intended by the manufacturer is forbidden.
The machine has been designed for an expected 100,000 work cycles and a heavy work regime (e.g.
10 years, 50 weeks a year, 40 hours a week, 5 cycles an hour).
The machine should be fully serviced and inspected by the manufacturer within the set number of
work cycles. In the event of particularly heavy use, the machine should be serviced sooner.
The machine should be inspected every 1,000 hours and serviced every 5,000 hours.
3.2
Direction
No.
DESCRIPTION
No.
DESCRIPTION
A
Upper
D
Bottom
B
Right-hand side
E
Left-hand side
C
Rear
F
Front
The following diagrams illustrate the references and the convention used to identify the machine’s
stabilizers.
F
E
D
C
B
A
Fig.
3.1
