63
CHAPTER 3
INTRODUCTION TO CLI
{ owner | neighbor }: Specify the ring port is a owner or neighbor. RPL (Ring Protection Link) is responsible for
blocking traffic over the RPL so that no loops are formed in the Ethernet traffic.
{ port0 | port1 }: Specify the port applies to this rule.
Negation:
(config)# no erps <group> rpl
Show: #
show erps [ <groups> ] [ detail | statistics ]
3.9.12.7 (config)# erps <group> sub port0 interface <port_type> <port0> { { port1 interface
<port_type> <port1> } | { interconnect <major_ring_id> [ virtual-channel ] } }
Syntax:
(config)# erps <group> sub port0 interface <port_type> <port0> { { port1 interface <port_type> <port1> } |
{ interconnect <major_ring_id> [ virtual-channel ] } }
Explanation:
Create a profile and configure the Sub ERPS interface port 0, port 1.
Parameters:
<group: 1-64>: Specify a group number. The allowed range is from 1 to 64.
<port_type> <port0>: Specify sub port’s port type and port number.
{ { port1 interface <port_type> <port1> } | { interconnect <major_ring_id> [ virtual-channel ] } }: Specify Port 1’s
port type and port numbr or specify major ring’s group ID.
Negation:
(config)# no erps <group>
Show: #
show erps [ <groups> ] [ detail | statistics ]
3.9.12.8 (config)# erps <group> topology-change propagate
Syntax:
(config)# erps <group> topology-change propagate
Parameters:
<group: 1-64>: Specify a group number. The allowed range is from 1 to 64.
Explanation:
Allow topology change notification propagation.
Negation:
(config)# no erps <group> topology-change propagate
Show: #
show erps [ <groups> ] [ detail | statistics ]
Содержание MSW-4424C Series
Страница 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Страница 382: ......
