Chapter 4. Web Configuration & Operation
230
CHAPTER 4
WEB OPERATION & CONFIGURATION
Falling:
Trigger alarm when the first value is less than the falling threshold.
Rising Threshold:
If the current value is greater than the rising threshold and the last sample value is less than this
threshold, then an alarm will be triggered. After a rising event has been generated, another such event will not be
generated until the sampled value has fallen below the rising threshold, reaches the falling threshold, and again
moves back up to the rising threshold. The threshold range is -2147483647 to 2147483647.
Rising Index:
Indicates the rising index of an event. The range is 1 - 65535.
Falling Threshold:
If the current value is less than the falling threshold, and the last sample value was greater than this
threshold, then an alarm will be generated. After a falling event has been generated, another such event will not be
generated until the sampled value has risen above the falling threshold, reaches the rising threshold, and again moves
back down to the failing threshold. (Range: -2147483647 to 2147483647)
Falling Index:
Indicates the falling index of an event. The range is 1 - 65535.
Click the “Add New Entry” button to insert a new entry to the list.
Click the “Delete” button to remove a newly-inserted entry or select the checkbox to remove a saved entry during the
next save.
Click the “Save” button to save settings or changes.
Click the “Reset” button to restore changed settings to the default settings.
4.3.4.1.8.4 RMON Event Configuration
RMON Event Configuration page is used to set an action taken when an alarm is triggered.
Delete:
Check to delete the entry. It will be deleted during the next save.
ID:
Specify an ID index. The range is 1 - 65535.
Desc:
Enter a descriptive comment for this entry.
Type:
Select an event type that will take when an alarm is triggered.
None:
No event is generated.
Log:
When the event is triggered, a RMON log entry will be generated.
snmptrap:
Sends a trap message to all configured trap managers.
logandtrap:
Logs an event and sends a trap message.
Community:
A password-like community string sent with the trap. Although the community string can be set on this
configuration page, it is recommended that it be defined on the SNMP trap configuration page prior to configuring it
here. The allowed characters are 0 - 127.
Содержание MSW-4424C Series
Страница 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Страница 382: ......
