103
CHAPTER 3
INTRODUCTION TO CLI
3.9.24.5 (config-if)# lacp role { active | passive }
Syntax:
(config-if)# lacp role { active | passive }
Explanation:
Configure LACP role for this interface.
Parameters:
{ active | passive }: Specify either “Active” or “Passive” role depending on the device’s capability of negotiating
and sending LACP control packets. Ports that are designated as “Active” are able to process and send LACP
control frames. Hence, this allows LACP compliant devices to negotiate the aggregated like so that the group may
be changed dynamically as required. In order to add or remove ports from the group, at least one of the
participating devices must set to “Active” LACP ports.
Negation:
(config-if)# no lacp role { active | passive }
Show:
# show lacp { internal | statistics | system-id | neighbour }
3.9.24.6 (config-if)# lacp timeout { fast | slow }
Syntax:
(config-if)# lacp timeout { fast | slow }
Explanation:
Configure timeout mode.
Parameters:
{ fast | slow }: The Timeout controls the period between BPDU transmissions. Fast will transmit LACP packets
each second, while Slow will wait for 30 seconds before sending a LACP packet.
Negation:
(config-if)# no lacp timeout { fast | slow }
Show:
# show lacp { internal | statistics | system-id | neighbour }
3.9.25 (config)# line
3.9.25.1 (config)# line
Syntax:
(configure)# line { <0~16> | console 0 | vty <0~15> }
Explanation:
Enter the specific line. When Enter is pressed, the command line changes to “(config-line)#”.
Parameters:
{ <0~16> | console 0 | vty <0~15> }: Specify one of the options.
<0
~
16> :
List of line numbers.
console 0:
Console line connection.
vty <0
~
15>:
VTY lines are the Virtual Terminal lines of the device, used solely to control inbound Telnet
connections. They are virtual, in the sense that they are a function of software - there is no hardware
associated with them.
Содержание MSW-4424C Series
Страница 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Страница 382: ......
