CTC Union IFS-1604GSM Series, Руководство пользователя, Страница: 139 / 385

139
CHAPTER 3
CLI CONFIGURATION
physically disconnected and reconnected on the port (by disconnecting the cable), the port will remain shut
down. There are three ways to re-open the port:
* Boot the switch
* Disable and re-enable Limit Control on the port or the switch
* Click the “Reopen” button
Example:
Send a SNMP trap when the limit is exceeded.
Negation: (configt-if)# no port-security violation
Show: > show port-security port [ interface ( <port_type> [ <v_port_type_list> ] ) ]
# show port-security port [ interface ( <port_type> [ <v_port_type_list> ] ) ]
3.9.34 (config)# privilege
Syntax: (config)# privilege { exec | configure | config-vlan | line | interface | if-vlan | ipmc-profile | snmps-host | stp-
aggr | dhcp-pool | rfc2544-profile } level <privilege> <cmd>
Explanation: This command is used to change the privilege level of commands available in Configuration mode.
Parameters:
{ exec | configure | config-vlan | line | interface | if-vlan | ipmc-profile | snmps-host | stp-aggr | dhcp-pool |
rfc2544-profile }: Specify the group command that you want to configure.
level <privilege>: Specify the privilege level. The allowed range is 0 to 15.
<cmd>: Initial valid words and literals of the command to modify, in 128 characters.
Example: The following example sets the privilege level to 15 for any Exec mode (user or privileged) command that
start with the letter "v"
Negation : (config)# no privilege { exec | configure | config-vlan | line | interface | if-vlan | ipmc-profile | snmps-host |
stp-aggr | dhcp-pool | rfc2544-profile } level <0-15> <cmd>
Show: > show privilege
# show privilege
3.9.35 (config)# ptp
3.9.35.1 (config)# ptp <clockinst> domain
Syntax:
(config)# ptp <clockinst> domain <domain>
Explanation: Configure the clock domain for PTP.
# config t
(config)# privilege exec level 15 host
# config t
(config)# interface gigabitethernet 1/1-10
(config-if)# port-security violation trap