- 8 -
w w w . C T C U . c o m
E1/T1
From the main menu, select item number 3 to access the E1/T1 status
menu.
<1> Termination Type – Use this item to set the transmission mode. The
modes available are E1 75, E1 120, or T1 100.
<2> E1/T1 Service – Enable or disable the transmission on this channel.
<3> Line Code – Set the appropriate line coding for the application.
<4> Loop Back Test Mode - Refer to page 10 for available loop back
modes.
Note: Both E1 and T1 support AMI (Alternate Mark Inversion) line coding.
However, in most cases, E1 will use HDB3 and T1 will use B8ZS line
coding.
[Local ] Version:[1.000-1.000-0.000-1.200] [ FOM01-SFP ] [CH01M ]
<< E1/T1 Status and Configuration >>
<1> Termination Type [ E1/75 /BNC ] Link [ Up ]
<2> E1/T1 Service [ On ] BVP Error[ Normal ]
<3> Line Code [ HDB3 ]
<4> Loop Back Test Mode [ Disable ]
<ESC> Go to previous menu. Please select an item.
[Local ] Version:[1.000-1.000-0.000-1.200] [ FOM01-SFP ] [CH01M ]
<< E1/T1 Status and Configuration >>
<1> Termination Type [ E1/75 /BNC ] Link [ Up ]
<2> E1/T1 Service [ On ] BVP Error[ Normal ]
<3> Line Code [ HDB3 ]
<4> Loop Back Test Mode [ Disable ]
<ESC> Go to previous menu. Please select an item.
----------------------------------------------------------------------
E1 /T1 Loop Back Test Function Select:
<1>: Disable <2>: LLB <3>: RLB
<ESC> Go to previous menu. Please select an item.
- 9 -
w w w . C T C U . c o m
LAN
From the main menu, select item number 4 to access the LAN status menu.
<1> LAN Service – Enable or disable the transmission on the LAN trunk.
<2> Negotiation – This LAN port supports both auto-negotiation per
IEE802.3u and manual forced mode. When in ‘auto’, the speed and duplex
settings are ignored.
<3> Speed – When using manual forced mode, the speed of the LAN can
be configured to either 10M or 100M.
<4> Duplex – When using manual forced mode, the duplex of the LAN can
be configured to either FULL or HALF duplex.
<5> LFP – The link fault pass through function allows a link failure to
propagate over the Ethernet trunk. If enabled, an Ethernet link loss on this
FOM01 will force a link down on the remote FOM01 LAN port.
****************************************
*** CTC UNION TECHNOLOGIES CO.,LTD ***
*** FRM220-FOM01 Manager Ver:1.00 ***
****************************************
[Local ] Version:[1.000-1.000-0.000-1.200] [ FOM01-SFP ] [CH01M ]
<< LAN Status and Configuration >>
<1> LAN Service [ On ] Link [ Up ]
<2> Negotiation [ Auto ]
<3> Speed [ 100 ] Status[ 100 ]
<4> Duplex [ Full ] Status[ Full ]
<5> Link Fault Pass Through Function [ Disable ]
<ESC> Go to previous menu. Please select an item.
----------------------------------------------------------------------
Link Fault Pass Through Function :
<1>: Disable <2>: Enable
<ESC> Go to previous menu. Please select an item.
