PC9/P9 CD-ROM Replacement
2
CTC Parker Automation
5. Swing the backshell away from the faceplate.
6. Detach the three cables connecting the faceplate assembly and
backshell. These cables are shown below.
a.
Detach the monitor (ribbon) cable from its connection at
the center of the monitor frame (push back the locking
clamps from either side of the connector).
b. If your system has a touchscreen, detach the touchscreen
cable from its extender in the maintenance compartment.
c.
Detach the backlight cable from its connection on the
monitor card (press down on the small tab on the lower
half of the connector, and pull the cable out).
7. Remove the safety bracket below the upper hinge of the backshell
by removing the screw that holds the bracket in place. This bracket
is shown in the illustration at the top of the next page.
Detach the
Detach the
Detach the
Monitor card
backlight cable
here
monitor cable
here
touchscreen
cable here
MAINTENANCE
COMPARTMENT