Articulating Desk Mount Arm with VESA Plate
ADD-ADMA
CONTENTS:
INSTRUCTIONS:
2A. When the C-Clamp is securely
attached to a surface, use the
provided security tool (C), attach to
security component, and rotate
closewise to put the C-Clamp in an
‘locked’ state. To loosen, rotate
counterclockwise with the security
tool.
Remove arm (D) from the
base clamp mount. Repeat
steps in reverse order to
re-install connection
2B. Align the (2) dimples on the underneath of the
security tool into the two holes on the security
component on the clamp as shown above
2C. Rotate counter-clockwise to
loosen and place the clamp in an
‘unlocked’ state. Continue rotating
until there is enough slack to rotate
the knob.Turn it clockwise to tighten
and place the clamp in a ‘locked’
state.
2
BASE CLAMP SECURITY SETUP
BASE MOUNT INSTALLATION
ARM & BASE CLAMP
ADJUSTMENTS
If you need to remove the arm
from the base clamp, take the
provided tool (B), rotate, and
loosen connection.
1
2
3
Find the included base
pad (E) and peel off the
backing. Align to the
underneath of the
C-Clamp (D) and apply
pad.
While the clamp is in unlocked mode, rotate the
knob at the bottom (as shown above) to loosen
or securely tighten to the table top.
ALIGNING SECURITY TOOL WITH SECURITY COMPONENT
A
B
C
D
E
F
E
D
B
D
C
C
