CSZ NORM-O-TEP 111Z, Руководство по эксплуатации и техническому обслуживанию

Страница: 53 / 82

Operation / Technical Manual NORM-O-TEMP, Model 111Z
Page 53 of 81
6-5. Replacement of the Water Filter Assembly.
A. Obtain a replacement water filter assembly.
B. Drain the reservoir and disconnect the power cord as described in Section 5-1.4.
C. Remove the three-sided enclosure panel as described in Section 6-1.3.
D. Locate the water filter assembly as shown in Figure 8.
E. Disconnect the assembly by loosening the plastic snapper clamps and sliding the
hoses off the barbed fittings.
F. Remove the T-shaped water filter assembly and discard.
G. Insert the replacement water filter assembly so that the cap and screen point
down and the arrow on the top points towards the front of the unit.
H. Reinstall the plastic snapper clamp.
I. Secure the three-sided enclosure panel as described in Section 6-1.4.
J. Refill the reservoir as described in Section 5-1.5.
6-6. Replacement of the Water Temperature Sensor.
A. Obtain replacement water temperature sensor.
B. Drain the reservoir and disconnect the power cord as described in Section 5-1.4.
C. Remove the three-sided enclosure panel as described in Section 6-1.3.
D. Locate the water temperature sensor in the end of the copper outlet (bottom)
manifold and disconnect it by unplugging the white 4 wire connector that is
located just below the front half of the reservoir as shown in Figure 8.
E. Using 7/16 inch wrench, unscrew and remove water temperature sensor from
the water manifold.
NOTE:
There may be small amounts of water in manifold.
F. Insert and tighten the replacement water temperature sensor into the copper
outlet (bottom) water manifold. The threads of the replacement water sensor
should be sealed with teflon tape.
G. Connect the water temperature sensor connector to the white 4 wire connector.
The connectors can be inserted only one way; check that the grooves are aligned.
H. Secure the three-sided panel as described in Section 6-1.4.
I. Refill the reservoir as described in Section 5-1.5.
J. Perform Electrical Safety Checks as described in Section 6-16. Perform both
Ground Integrity (Section 6-16.1) and Leakage Current (Section 6-16.2).