HV DTemp Measurement System – Using a HV DTemp Measurement System
User Guide
35
Version 01.00 // 2021
Check the interface connection or connect a suitable interface.
Close DTEMPconfig and restart the program.
⇨
The interface should now be available in the selection menu of the
Interface
dialog.
→ Further information on this topic can be found in the DTEMPconfig online help on page
"Interface (Dialog)".
5 3 2 2 Creating a configuration
Scan Bus and Auto-Configuration
Both functions can be used to identify modules connected to the bus and to read out
stored configurations. In addition to the module detection,
Auto-Configuration
features an
option to solve possibly existing ID conflicts. However, an automatic channel configuration
in its actual sense (e.g. setting the measurement range) is not performed.
i
To create an initial configuration with multiple new HV DTemp-P central
units, CSM recommends using
Auto-Configuration
because all new measu-
rement modules are set to the same CAN ID.
Reading in a configuration
The configuration is read in using the
Scan Bus
command.
Start DTEMPconfig.
⇨
The DTEMPconfig program window opens.
Fig. 5-17: DTEMPconfig user interface, no configuration window opened
If DTEMPconfig cannot detect an interface, the
Interface
dialog opens and indicates a mis-
sing interface connection.
→ See chapter 5.3.2.1 "Starting the program", section "Selecting an interface".
Running Scan Bus
Scan bus
checks the CAN bus for connected devices (central unit(s) and controllers). The
configuration data is compiled to be finally saved in a DBC file.
