HV DTemp Measurement System – Mounting and Installation
User Guide
26
Version 01.00 // 2021
Fig. 4-9: Do not kink the sensor cable (left), but carefully bend it over the edge (right)
Proceed as follows to fix the sensor(s) on the measuring point:
Position the sensor directly on the measuring point.
Remove the protective foil from the Kapton
®
foil and use the Kapton
®
foil to
mount/fix the sensor at the measuring point.
4 3 3 4 Mounting the controllers
For safety reasons the controllers must also be fixed in order to minimize mechanical strain. For
this purpose, the controllers are equipped with mounting lugs
➀
which are used to attach the
controller to the intended mounting location using suitable fastening material (e.g. cable ties).
Fig. 4-10: Controller, mounting lugs
4 3 3 5 Encoding switches
Whether only one or more controllers are connected to a measurement input, you have to
make sure that
f
… the required ID is set on each controller.
8
f
… the last controller of a chain is terminated.
The setting of the controller ID and the termination of a controller is done by using the
encoding switches (see Fig. 4-11).
8 Make sure that an ID is only used once per measurement chain.
➀
➀
